• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENABLING OBJECTIVES (cont.) - h1016v1_51
Symbology - h1016v1_54

Engineering Symbology Prints and Drawings Volume 1 of 2
Page Navigation
  29    30    31    32    33  34  35    36    37    38    39  
DOE-HDBK-1016/1-93 Engineering Fluid Diagrams and Prints ENGINEERING FLUIDS DIAGRAMS AND PRINTS ENGINEERING FLUIDS DIAGRAMS AND PRINTS To read and understand engineering fluid diagrams and prints, usually referred to as P&IDs, an individual must be familiar with the basic symbols. EO  1.1 IDENTIFY  the  symbols  used  on  engineering  P&IDs  for  the following  types of  valves: a. Globe  valve g. Relief  valve b. Gate  valve h. Rupture  disk c. Ball  valve i. Three-way  valve d. Check  valve j. Four-way  valve e. Stop  check  valve k. Throttle  (needle)  valve f. Butterfly  valve l. Pressure  regulator EO  1.2 IDENTIFY  the  symbols  used  on  engineering  P&IDs  for  the following  types of  valve  operators: a. Diaphragm  valve  operator b. Motor  valve  operator c. Solenoid  valve  operator d. Piston  (hydraulic)  valve  operator e. Hand  (manual)  valve  operator f. Reach  rod  valve  operator EO  1.3 IDENTIFY    the    symbols    used   on    engineering    P&IDs   for educators and  ejectors. EO  1.4 IDENTIFY  the  symbols  used  on  engineering  P&IDs  for  the following  lines: a. Process b. Pneumatic c. Hydraulic d. Inert  gas e. Instrument  signal  (electrical) f. Instrument  capillary g. Electrical Rev. 0 PR-02 Page 1







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.