TERMINAL OBJECTIVE - h1016v1

ENABLING OBJECTIVES (cont.) - h1016v1_50

Engineering Symbology Prints and Drawings Volume 1 of 2
Page Navigation
31

Engineering Fluid Diagrams and Prints DOE-HDBK-1016/1-93 OBJECTIVES TERMINAL OBJECTIVE 1.0 Given an engineering print, READ and INTERPRET facility engineering Piping and Instrument Drawings. ENABLING OBJECTIVES 1.1 IDENTIFY the symbols used on engineering P&IDs for the following types of valves: a. Globe valve g. Relief valve b. Gate valve h. Rupture disk c. Ball valve i. Three-way valve d. Check valve j. Four-way valve e. Stop check valve k. Throttle (needle) valve f. Butterfly valve l. Pressure regulator 1.2 IDENTIFY the symbols used on engineering P&IDs for the following types of valve operators: a. Diaphragm valve operator b. Motor valve operator c. Solenoid valve operator d. Piston (hydraulic) valve operator e. Hand (manual) valve operator f. Reach-rod valve operator 1.3 IDENTIFY the symbols used on engineering P&IDs for educators and ejectors. 1.4 IDENTIFY the symbols used on engineering P&IDs for the following lines: a. Process b. Pneumatic c. Hydraulic d. Inert gas e. Instrument signal (electrical) f. Instrument capillary g. Electrical Rev. 0 Page vii PR-02

Privacy Statement
Press Release
Contact